17016 Exposure Head HEAD: is not responding Thermal The exposure head is not responding. The exposure head to backplane (EH-BP) cable should be checked. The exposure head's digital board should also be checked (parameters stored in EEPROM must be restored if the board is swapped). Check that the board has +5V. The MPE may also be faulty. Reboot the platesetter. Even if this error does not happen again, please report it to Creo Service as the Platesetter may need servicing. Faulty EH-BP (exposure head to backplane) cable Exposure head digital board faulty or not mounted correctly Faulty MPE ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:33 2008 PST